Hobart Welding Products 217 694E, OM-925 manual Threading Welding Wire, Lay gun cable out straight

.A complete Parts List is available at www.HobartWelders.com

5-9. Threading Welding Wire

	1	Wire Spool
	2	Welding Wire
	3	Inlet Wire Guide
	4	Pressure Adjustment Knob
	5	Drive Roll
4	6	Gun Conduit Cable
	Lay gun cable out straight.
	6

Tools Needed:

1 2 3 5

1

Open pressure assembly. Make sure feed roll is set to correct groove to match wire size (see Section 7-4).

2

.Hold wire tightly to keep it from unraveling.

6 in (150 mm)

Pull and hold wire; cut off end.

3

4 in (102 mm)

Straighten approximately 3 or 4 inches (76 or 102 mm) of wire before inserting

wire into guides. Push wire thru guides into gun; continue to hold wire.

OM-925 Page 20