COMMUNICATIONS GUIDE
Code
Bit 8
Bit 9
Bit 10
Bit 11
Bit 15
Bit 16
Bit 17
Bit 18
Bit 19
Bit 20
Bit 21
Bit 22
Bit 23
Bit 24
Bit 25
Bit 26
Bit 27
Bit 28
FC192
Bit 0
Bit 1
Bit 10
Bit 11
Bit 13
Bit 20
Bit 21
Bit 22
FC193
FC194
FC212
0
1
2
3
RS485 INTERFACE (MODBUS RTU)
Type | Definition |
| Forward Limit |
| Reverse Limit |
| Starts/Hr Inhibit |
| Time Between Inhibit |
| Comms Ctrl Active |
| Hard Wired Ctrl Active |
| Field Ctrl Active |
| MCC Ctrl Active |
| Process ILock A Stop |
| Process ILock B Stop |
| Process ILock C Stop |
| Process ILock D Stop |
| Process ILock E Stop |
| Process ILock F Stop |
| Process ILock G Stop |
| Process ILock H Stop |
| Process ILock I Stop |
| Process ILock J Stop |
32 bits | Ctrl Element Status 2 |
| Access Switch |
| Test Switch |
| Remote Reset |
| Lockout Reset |
| |
| Fuse Fail Inhibit |
| Phase Reversal Inhibit |
| Low Aux Voltage Inhibit |
32 bits | Ctrl Status 3 (Reserved) |
|
|
32 bits | Ctrl Status 4 (Reserved) |
16 bits | LCD Test Paint Color |
| None |
| Red |
| Green |
| Blue |
|
|
Performing Commands Using Function Code 10H
Commands can be performed using function code 16 as well as function code 5. When using FUNCTION CODE 16, the Command Function register must be written with a value of
5.The Command Operation register must be written with a valid command operation number. The Command Data registers must be written with valid data; this is dependent upon the command operation.
For example, consider a request for slave 17 to perform command operation 1 (RESET): The master/slave packets have the following format:
MM300 MOTOR MANAGEMENT SYSTEM – COMMUNICATIONS GUIDE | 49 |