Support Brackets | Collector |
There are two lower collector support brackets and one upper bag support bracket. Attach the collector brackets to the top edge of the base plate using four (4) 5⁄16"-18 x 1⁄2" hex bolts provid- ed, as shown in Figure 5.
Figure 5. Mounting brackets to base.
The collector attaches to each support bracket. The inside of the collector is funnel shaped and directs the air around in a cyclone motion. Make sure that the inside taper (funnel) is faced down- ward and the collector inlet faces toward the col- lector body.
Secure the front support bracket to the collector with two (2) 5⁄16"-18 x 3⁄4" hex bolts provided. Before securing the rear support bracket to the collector, line up the upper bag support bracket bolt holes with the collector support bracket bolt holes and the collector. Secure with two (2) 5⁄16"- 18 x 3⁄4" bolts provided, as shown in Figure 6.
Figure 6. Mounting collector to brackets.
-12- | G1028Z/G1029 Dust Collector |
