SECTION 6: OPERATIONS
Test Run
Disconnect power to the machine when perform- ing any maintenance, assembly or adjust- ments. Failure to do this may result in serious personal injury.
Keep loose clothing rolled up and out of the way of machinery and keep hair pulled back.
Wear safety glasses dur- ing the entire operations process. Failure to com- ply may result in serious personal injury.
Always wear a dust mask when operating your dust collector. This machine circulates saw- dust which may cause allergic reactions or res- piratory problems.
Once assembly is complete and adjustments are done to your satisfaction, you are ready to test run the machine.
Turn on the power supply at the main panel. Press the START button. Make sure that your fin- ger is poised on the STOP button, just in case there is a problem. The dust collector should run smoothly, with little or no vibration or rubbing nois- es. Strange or unnatural noises should be investi- gated and corrected before operating the machine further.
If you cannot easily locate the source of an unusual noise or vibration, contact our service department for help.
General
Operating your Model G1028Z/G1029 is simple and straightforward. Blast gates located at each of the machines controls the air flow from the woodworking machine to the dust collector. If a machine is not being used, keep the blast gate closed to maintain higher levels of efficiency throughout the system.
DO NOT use the dust collector for any other purpose besides collecting dust from con- nected woodworking machines. A dust col- lector should NEVER be used as an air cleaner. For safest use, wear a dust mask and use an air cleaner in addition to the dust collector.
G1028Z/G1029 Dust Collector |