Grizzly instruction manual Inlet, Installing Y inlet G1028Z/G1029 Dust Collector

Page 16

3.Slip the steel band around the bag and tight- en down as shown in Figure 10.

Figure 10. Tightening steel band.

4.Slip the bottom collection bag over the bot- tom edge of the collector and pull the strap tight to secure the bag.

5.Place the steel band with the quick clamp over the bag and clamp on the tightest notch possible.

DO NOT force the clamp. Instead, choose the next notch over, then clamp in place.

Inlet

Press the “Y” inlet onto the inlet cover flange as shown in Figure 11. The inlet is secured to the collector body by a press-on fit.

Figure 11. Installing “Y” inlet.

-14-	G1028Z/G1029 Dust Collector

Image 16

Contents Dust Collector Model G1028Z/G1029Page Table Of Contents Safety Safety Instructions For Power ToolsLength AMP Rating Additional Safety Instructions For Dust Collector G1028Z Wiring Circuit RequirementsGrounding Extension Cords Introduction CommentaryUnpacking Piece InventoryClean Up Site ConsiderationsAssembly Beginning Assembly BaseCollector Body OutletSupport Brackets CollectorFlex Hose Bags Securing collection bag G1028Z/G1029 Dust CollectorInstalling Y inlet G1028Z/G1029 Dust Collector InletGeneral Material SelectionSystem Grounding Plastic DuctFlex-hose grounded to machine G1028Z/G1029 Dust Collector Design Suggestions Bird’s eye planning view G1028Z/G1029 Dust CollectorOperations Test RunBag Cleaning MaintenanceLubrication Closure Wire Diagram Machine Data Sheet 6A G1029 Caster Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC