Craftsman 351.223140 operating instructions Cut-awayviewof

MOUNT DUST COLLECTOR ASSEMBLY TO WALL Refer to Figure 4.

To mount dust collector assembly:

•Lift dust collector assembly and position slots in wall brackets over installed anchored screws. Slide dust collec-

tor assembly down so that anchored screws rest in narrow portion of slots.

NOTE: Mounting dust collector will be easier and safer if done by two people.

•Tighten four screws using offset or short Phillips head screwdriver.

Anchored Screw

Figure 4 - Mounting Dust Collector Assembly

ATTACH COLLAR

Refer to Figure 5.

Collar needs to be attached to lower flex-ring of filter. To attach lower collar:

•Pull filter down from dust collector housing.

•Make sure that filter is straight and there are no folds or creases.

•Bend and insert lower flex-ring of filter into upper collar channel.

•Pull down on collar to make sure that flex-ring is entirely in channel.

			_Housing			Channel
			_0_	._r__ (Inner)
				j'-Cut-awayviewof
			_/	_//	Upper	Housing
				Loop
		/		i'_"-" Filter
Upper		Flex-ring	_	y)
		_Upper			Collar
		/"	-_[_-	,Channel		(Inner)
	Lower Flex-ring __
				_[_//Collar
			....	\Lower	Collar
Figure	5 -	Attach Collar		Channel		(Outer)
ATTACH	COLLECTOR		BAG
Refer to	Figure 6.

Collector bag needs to be attached to collar using collector bag clamp. To attach collector bag:

•Remove collector bag clamp from collar.

•Slide collector bag over collar. Position bag approximately 2W' above lower edge of collar.

NOTE: The bottom of collector bag should rest flat on the floor, so that the floor supports the weight of wood dust and chips.

•Position bag clamp in lower channel of collar over bag.

•Position the spring connector into one of the slots on the latch and lock the clamp handle.

•Make sure collector bag is secure.

NOTE: The top of collector bag should NOT block the filter. If collector bag does block filter, fold excess bag over bag clamp.

Collector Bag

Figure 6 - Attaching Collector Bag

4