Alpha Tool.Com.HK Limited ECOGRDGR Installing the Dust Collection Cover, Installing the Connector

Page 5

INSTALLING THE DUST COLLECTION COVER

WARNING!

1.Be sure to turn off the high-speed angle grinder and remove the plug from the electrical outlet before attaching and installing the Dust Collection Cover.

2.Take the Guard off from the Grinder

2.Make sure the Dust Collection Cover is securely attached, otherwise it may come loose which could cause injury.

3.If you installed the Dust Collection Cover to a high-speed angle grinder but the connector is loose and cannot be securely attached, do not use the Dust Collection Cover. Using it in this state could cause injury.

INSTALLING THE CONNECTOR

ALPHA® /

BOSCH

HITACHI

METABO®

DEWALT

MAKITA®

 

 

 

 

HSG-125

1801

G12SR3 G13SE2

WE9-125 Quick

D28402 & D28131

 

9565CV, 9558NB

& G12SS

& W11-125 Quick

 

 

 

 

 

 

(Factory Preset)

(Fig.1)

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Alpha Ecoguard Type G Dust Collection Cover Table of Contents Introduction About the SymbolsPrecautions for Using Dust Collection Cover Ecoguard Type G Overview AccessoriesInstalling the Connector Installing the Dust Collection CoverPlace in the other Connector Tighten the Screws Do not forget to insert Spring Washers Mounting the Grinding CUP Wheel to the Grinder Be careful to ensure the correct direction of the Lock Nut HSG-125 9565CV 9558NB G12S43 G13SE2 Wall Grinding Grinding ApplicationsSurface Grinding Attaching the Dust Collector Alpha Ecoguard Type G Schematic Ecoguard Type G Other Connectors and Spacers Drawing no Description Quantity Alpha Ecoguard Type G Parts ListBauer Drive, Oakland, NJ 07436 800-648-7229 Fax
Top Page Image Contents