2,
2,
Fig. 6
DO NOT assemble the Dust Collector until you are sure the tool iS NOT plugged in,
DO NOT assemble the Dust Collector until you are sure the power switch is in the "OFF" position,
For your own safety, DO NOT connect the machine to the power source until the machine is completely
assembled and you read and understand the entire Owner's Manual,
SWIVEL CASTER TO
BASE ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR IS DISCONNECTED FROM THE POWER SOURCE.
1, Place the dust collector on its side,
3,
4,
Place 3/8=16 flange hex nut (C) onto bolt (D) of swivel caster and tighten, See figure 6,
Repeat Steps 2, 3 and 4 above to assemble the remaining swivel caster assemblies to base,
Fig. 5
EXHAUST FLANGE ASSEMBLY
MAKE CERTAIN THE DUST COLLECTOR iS
DISCONNECTED FROM THE POWER SOURCE.
A
)
2, insert bolt on the swivel caster assembly through each one of the four hobs (A), in the base of the dust collector, See figure 5,
1, Align the hobs in the exhaust flange (A) with the hobs in the exhaust flange gasket (B), See figure 7,
10