Craftsman 152.213351 operating instructions

2.Hnserttwo5/16-18x 5/8"buttonheadcarriageboHts iNTAKE PORT CAP AND

throughtheinsideoftheintakefunneiandintake HOSE ASSEMBLY supportbrace.

3.Piace a 5/16-18 flange hex nut onto the button head carriage boits and tighten secureiy.

MAKE CERTAIN THE DUST COLLECTOR IS DISCONNECTED FROM THE POWER SOURCE.

F Fig. 14

A

D

C

E

4, Attach the upper support bracket (C) to the hob (D) in the intake support brace with the adjustabie Hock- ing iever (E). Piace a 5/16" Hockwasher (F) onto Hocking iever boit before attaching to the intake support brace. See figure 12.

Fig 13 .J_--

G

E D

1, SHde the collar (A) of the intake port cap (B) over intake port (C). Make sure the collar is position to the back if you intend to attach the hose at this time. See figure 14.

2.PHace4-inch hose champ (D) onto the end of 4qnch fiexibie hose (E). See figure 14.

3.Siide end of 4-inch fiexibie hose with 4-inch hose champ onto intake port and tighten secureiy.

IMPORTANT: When connecting a flexibie hose to intake port, DO NOT REMOVE THE INTAKE PORT CAP COLLAR FROM THE INTAKE PORT. Siide the collar further back when attaching a fiexibie hose.

5, Place intake funnel assembly (G) onto lower sup- port tube (H) and tighten tube clamp (I) securely, See figure 13,

12