Turnthepowerswitch"OFF"andunplugthepower | airmaydamageinsulation.Theoperatorshouldalways |
cordfromitspowersourcepriortoanymaintenance, | weareyeprotectionwhenusingcompressedair. |
Alwaysmakesurethattheintakeportcapscoversthe | Donotallowchipsanddusttoaccumulateunderdust |
intakeportwhena hoseis notconnectedtothedust | |
collector. | collector.Keepareacleanandin safeorder. |
| CAUTION:DONOTUSEFLAMMABLEMATERIALS |
TheDustCollectorhassealedlubricatedbearingsin | tocleanDustCollector. |
| |
themotorhousingthatdoesnotrequireanyadditional |
|
lubricationfromtheoperator, | Repairsto theDustCollectorshouldbeperformedby |
| |
| trainedpersonnelonly.ContactyournearestSears |
| ServiceCenterforauthorizedserviceUnauthorized. |
WiththeDustCollectorunplugged,blowoffmotorwith | repairsor |
lowpressureairto removedustordirt, Airpressure | causeseriousinjurytotheoperatoranddamageto the |
above50 R S. I. shouldnotbe | DustCollector. |
TOPREVENTINJURYTOYOURSELFordamageto theDustCollector,turntheswitchto the"OFF"positionand unplugthepowercordfromtheelectricalreceptaclebeforemakinganyadjustments,
PROBLEM | LIKELY CAUSE(S) |
| SOLUTION |
|
|
| ||||||
Motor does | 1. | Switch | not pressed | in tar enough or | 1. | Depress | switch | in 1/2 | inch or make sure switch | |||
not start |
| switch | in the "OFF" | position |
| is in the | "ON" position. |
| ||||
| 2. | Detective | switch |
| 2. | Have | switch | replaced. |
| |||
| 3. | Detective | capacitor |
| 3. | Have | capacitor | replaced. | ||||
| 4. | Low line | voltage |
| 4. | Correct | low | line | voltage | condition. | ||
| 5. | Detective | motor |
| 5. | Have | motor | replaced/repaired. | ||||
|
|
|
|
|
| NOTE: 2, 3 and 4 must be done by a qualitied service | ||||||
|
|
|
|
|
| technician; | Contact | Sears | service. | |||
Motor | stalls | 1. | Circuit overload |
| |
(resulting | in blown | 2. | Low line voltage |
| |
fuses | or tripped | 3. | Chips or debris clogged | impeller. | |
circuit | breakers) |
|
|
| |
|
|
| 4. | Motor ovedoad |
|
|
|
| 5. | incorrect tuses on circuit | breakers |
|
|
| 6. | Short circuit in motor; loose connections | |
|
|
|
| or worn insulation on lead wires | |
Motor | starts | 1. | Detective motor windings |
| |
slowly | or falls to | 2. | Detective capacitor |
| |
come | to full speed |
|
|
| |
Motor | running | 1. | Restricted air circulation due to dust | ||
too hot |
|
| accumulation. |
| |
|
|
| 2. | Motor overload |
|
Frequent | opening | 1. | Fuses or circuit breakers do not have | ||
of fuse or | circuit |
| sufficient capacity |
| |
breakers |
| 2. | Circuit overloaded |
| |
|
|
| 3. | Motor overload |
|
1.Reduce circuit load
2.Correct low line voltage condition.
3.Clean all hoses, bags and blower housing of chips and debris.
4.Reduce load on motor.
5.Have correct tuses on circuit breakers installed.
6.inspect terminals in motor for damaged insulation and shorted wires and have them replaced.
1.Have motor replaced/repaired.
2. Have capacitor replaced.
1A, Clean dust and restore normal air circulation. 1B. Empty and clean tilter and collection bags.
2.Reduce load on motor.
1.Have correct tuses or circuit breakers installed.
2.Reduce circuit load (turn off other appliances).
3.Reduce load on motor.
18