Invacare user manual Features, Model IOC100P

Page 10

SECTION 2—FEATURES

SECTION 2—FEATURES

DANGER

This product is not intended as a life‐sustaining or life‐supporting device.

CAUTION

Missing or illegible labels MUST be replaced. Contact customer service at the number on the back page.

Model IOC100P

Cylinder Post Valve

T-Handle Clamp

Cylinder Alignment Pins

CGA870 Seal Washer

Selector Switch

Oxygen Pressure Gauge w/ Rubber Guard

Oxygen Supply

Outlet Fitting

Vent Hole

FIGURE 2.1 Model IOC100P

Cylinder Post Valve T‐Handle Clamp: This is used to attach the unit to any CGA870 post‐valve cylinder.

Oxygen Pressure Gauge: Enables the user to monitor the contents of the compressed oxygen cylinder and is protected by a rubber guard.

Invacare® Element™

10

Part No 1160840

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Invacare Element Pneumatic Conserver Accessories Warning Table of Contents Special Notes WordPrinciples of Operation Introduction General Guidelines Operating InformationGeneral Guidelines General Guidelines Features Model IOC100PConnection view of the IOC100P with CGA870 Installing the Conserving Regulator Cylinder post valve Operating Instructions Cannula Placement Operating Instructions Selector Switch Removing the Conserving Regulator Typical Product Parameters RegulatorOxygen Cylinder Duration Maintenance Troubleshooting SolutionLimited Warranty USA
Related manuals
Manual 32 pages 60.36 Kb
Top Page Image Contents