MITER GAUGE
(3)
MITER GAUGE KNOB
ANGLE SCALE
FIGURE K
To Adjust The Sand Belt Frame For Vertical Sanding:
Loosen the two Nuts (36) on the Sanding Belt Frame (40), and with assistance raise the Sanding Belt Frame to its full vertical position. Then, firmly retighten the two Nuts to lock the Sanding Belt Frame in place. (See Figure L.)
NUT (36) | SANDING BELT FRAME (40) |
| (VERTICAL POSITION) |
FIGURE L
To Adjust The Position Of The Table:
1.When the Sanding Belt Frame (40) is in its vertical position, the Table (1) should be repositioned to the front of the Sanding Belt Frame. (See Figure M, next page.)
2.To reposition the Table (1), loosen the two Set Screws (14) and remove the Table, including the Support Bar (18). (See Figure M.)
3.Insert the Support Bar into the Mounting Hole, and tighten the other two Set Screws (14). (See Figure M.)
REV 04b
SKU 06852 | For technical questions, please call | PAGE 13 |