PRODUCT SPECIFICATIONS
Electrical Requirements | 1 HP, Ball Bearing Motor |
| 110 Volt/60 Hz/12.8 Amps |
| 3450 Rpm |
Overall Height | 40” |
Table Surface Dimensions | |
Table Tilt | |
Work Table Options | For Sanding Disc or Sanding Belt |
| Use |
Belt Size | 6” x 48” |
Disc Size | 9” Diameter, PSA Type |
Belt Speed | 1280 FPM |
Disk Speed | 1720 RPM |
Weight | 121 lb. |
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, op- erating, inspection, maintenance and cleaning procedures, parts list and assem- bly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place for future reference.
GENERAL SAFETY WARNINGS AND PRECAUTIONS
1.KEEP WORK AREA CLEAN AND DRY. Cluttered, damp, or wet work areas invite injuries.
2.KEEP CHILDREN AWAY FROM WORK AREA. Do not allow children to handle this product.
3.STORE IDLE EQUIPMENT. When not in use, tools and equipment should be stored in a dry location to inhibit rust. Always lock up tools and equipment, and keep out of reach of children.
4.DO NOT USE THIS PRODUCT IF UNDER THE INFLUENCE OF ALCOHOL OR DRUGS. Read warning labels on prescriptions to determine if your judgement or reflexes are impaired while taking drugs. If there is any doubt, do not attempt to use this product.
| For technical questions, please call | REV 07g |
SKU 06852 | PAGE 2 |