Harbor Freight Tools 6852 To Assemble The Pulleys, Sanding Disc Plate, and Table, Figure E

To Assemble The Pulleys, Sanding Disc Plate, and Table:

1.Remove the 4 screws from the cover on the Pulley Cover (22) and set aside.

2.	Line up the three bolt holes on the Pulley Cover		FIGURE E
	(22) with the threaded holes in the Bracket
	(26). Place a Washer (21) over each of 3
	Screws (20). Insert a Screw (20) into each
	hole and tighten. (See Figure E.)
3.	This item is packed with tape on the shafts	Screw (20)
	to keep the keys in place. Remove the
	tape from the upper shaft, being careful
	to not lose the key.
4.	Loosen the Set Screw (14) on the Large
	Pulley (19). Put the Large Pulley on the upper
	shaft, with the smaller step on the pulley inside and
	with the key lined up with the slot on the Pulley. Be sure
	the key stays in the correct position, all the way through the
	pulley.
5.	Repeat steps 3 and 4 putting the Small Pulley (52) on the lower shaft.			( S e e
	Figure F.)

6.Carefully align both pulleys and tighten. Use a flat head screwdriver through the slot in the Pulley Cover (22) to tighten the Set Screw (14) on the Large Pulley (19). (See Figure G.) Use a hex key (not included) to tighten

FIGURE G		the Set Screw (14) on the Small Pulley (52).
7.		Loosen the 4 Screws (48) that hold the Motor
		(30) just enough to let the Motor move. Move the
			Motor towards the Large Pulley enough
	hole for Support Bar (18)		to let the Belt (17) slip on over both
			Pulleys. Move the Motor away from the

Large Pulley until the Belt is tight enough so
that, if pushed, it doesn’t move more than 1/2”.	Large Pul-	FIGURE F
Hold the Motor in place while you retighten the	ley (19)
4 Screws (48).

8.Put the Sanding Disc Plate (16) on the end of the shaft so that it’s flush with the end of the shaft. Tighten its set screw, once again using the slot in the Pulley Cover (22). (See Figure G.)

9.Check to make sure the Sanding Disc Plate (16) is free of dirt, oil, and other debris.

Small Pul- ley (52)

REV 04b

SKU 06852 For technical questions, please call 1-800-444-3353. PAGE 9