Heath Zenith SL-4300 warranty Adjustment of Coverage Area, Specifications

The sensor is less sensitive to motion directly towards it and more sensitive to motion across coverage area.

Motion

Motion

Sensor

Adjustment of Coverage

Area

The sensor on this light fixture detects “motion” by the movement of heat (body heat) across the coverage area. However, following are examples of objects that also produce heat and can cause the sensor to false trigger:

If you suspect that a heat source of this type is falsely triggering the sensor and reducing the sensitivity does not solve the problem, then a lens shield (included) can be installed. The plastic lens shield is divided into 6 sections. Each section will reduce the coverage angle by 30 degrees. Also, the tip of each section may be removed to change the effective range of the sensor.

Portion

Removed

598-1183-03

2.Cut desired amount of foam

tape needed to adhere the lens

shield to the sensor lens.

3.Remove paper backing from one side of cut foam tape and adhere foam tape to inside of lens shield.

4.Removepaperbackingfromothersideofcutfoam tape and adhere lens shield to sensor lens.

5.Retest to confirm that the sensor is no longer false triggering.

Note: To help determine amount of lens shield required, apply small sections one at a time. Ad- ditional sections can be applied if necessary.

SPECIFICATIONS

HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.