Horizontal Junction Boxes Only:
|
| Ground | |
Fixture |
| Screw | |
Wire |
| ||
Screw | Fixture | ||
Path | |||
|
Black
Light
Green 
Fixture or Bare
White
Screw |
Junction |
Box |
Screws |
Remove ground screw and 2 fixture screws from the mounting plate. Flip plate over.
White
Black
Green or Bare
One Motion Light
LightLight
Fixture Fixture
Two Motion Lights
WIRING
Note: All wiring should be run in accordance with the National Electrical Code through conduit or another acceptable means.
Contact a qualified electrician if there is any question as to the suitability of the system.
CAUTION: DO NOT connect the RED wire unless you want to control other lights from the motion sensor.
❒Twist the junction box wires and the fixture wires together as shown below. Secure with wire connectors. If you have a metal junction box, you may not need the green“pigtail”.If you are unsure about the grounding method, consult your local building code.
Connect the fixture wires to the wires in the junction box. Twist the wires together and secure with wire connectors.
Recommended Grounding Method
Use a green ground “pigtail” (not provided) and twist one end together with the bare fixture wire and the box ground wire. Secure with a wire connector. Secure the other end of the "pigtail" with the GND screw on the mounting plate.