Heath Zenith 598-1283-00 warranty Complete Installation, Testing, Avoid aiming the control at

COMPLETE THE

INSTALLATION

❒Stuff the wires into the junction box. Make sure the wires from the fixture go through the wire path, and no wires get pinched.

TESTING

❒Turn on the circuit breaker and light switch.

NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on or when switching modes wait 1 1/2 minutes.

❒Switch the on-time to TEST position and DualBrite® switch to the off position.

			SK		T	O
						N
			U	AW
		6	D D
F	3
F
O

Controls facing downward

Slide the fixture onto the mounting

screws and tighten nuts.

❒Caulk fixture mounting surface with silicone weather sealant. You may want to wait until you have completed the tests and adjustments on pages 4 and 5.

❒Install one 100 Watt max. light bulb.

TEST 1 5 10 MIN		OFF 3 6 DUSK TO
	ON-TIME		HOUR DAWN

Avoid aiming the control at:

•Objects that change temperature rapidly, such as heating vents and air condition- ers. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearby large, light-colored objects re- flecting light may trigger the shut-off feature. Do not point other lights at the sensor.

598-1283-00