Heath Zenith 4162 warranty Testing, Turn on the circuit breaker and light switch, Lo M Hi

TESTING

❒Turn on the circuit breaker and light switch.

Note: Sensor has a 1 1/2 minute warm up pe- riod before it will detect motion.When first turned on wait 1 1/2 minutes.

❒Set SENSITIVITY to mid position and ON-TIME to TEST position.

TEST 1 5 10 MIN	LO - M - HI
ON-TIME	SENSITIVITY

Avoid aiming the control at:

•Pools of water or objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

•Areas where pets or traffic may trigger the control.

•Nearbylarge,light-coloredobjectsreflect- ing daylight may trigger the shut-off feature. Do not point other lights at the sensor.

The detector is less sensitive to motion di- rectly towards it and more sensitive to across motion.

MotionMotion

Sensor

Least Sensitive Most Sensitive

❒Walk through the coverage area noting where you are when the lights turn on. Move the sensor head left or right to change the coverage area.

Note: Grasp the sensor only as shown and turn the entire sensor. Any other method may damage the sensor. Do not force it past the stops.

150°

6 ft.

(1.8 m)

30ft.

(9.1m)

Maximum Range	Maximum
	Coverage Angle

240°	Sensor Aiming
	Adjustment Angle

❒SettheSENSITIVITYasneeded.Toomuch sensitivity may increase false triggering.

❒Set the amount of TIME you want the light to stay on after motion is detected (1, 5, or 10 minutes).

595-5530-13