Mode Switching Summary, DualBrite Timer | Heath Zenith 5797 specification

MANUAL MODE	INSTALLATION

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 20 position.

1 Second OFF

then...

... back on.

For easy installation, select an existing light operated by a wall switch for replacement.

For best performance, mount the fixture about 8 ft. (2.4

m)above the ground. NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming the sensor down will reduce coverage distance.

CAUTION: Keep the sensor at least 2" (51 mm) away from the lamps.

CAUTION: To Avoid Fire Or Burn Hazards:

• Allow fixture to cool before touching. The bulb and the

fixture operate at high temperatures.

• Keep fixture at least 2" (51 mm) from combustible ma-

terials. Do not aim at objects closer than 3 feet. (1 m).

Mode Switching Summary

TEST Move ON-TIME Switch to 1, 5, or 20 minutes

AUTO

Flip light switch

off for one second

• Use only T4, 100W (max.) G8 bi-pin tungsten halogen

120 VAC lamps.

For under eave installation, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock. Also for proper under eave operation, remove the protective backing from the light shield and stick on as

MANUAL MODE

then back on*

shown below.

*If you get confused while switching modes, turn the power off for one minute, then back on. After the cali- bration time the control will be in the AUTO mode.

DualBrite® Timer

Light comes on half bright for selected time after dusk (Off, 3 hr., 6 hr., until dawn). Selecting OFF disables this feature. The motion sensing features will continue to work as described in this manual. If motion is sensed, the light turns on full bright for the ON-TIME (1, 5, or 20 minutes) then returns to dim mode.

Lamp Modes

There are three lamp modes (light turn-on effects) avail- able when motion is detected:

•NORMAL - Light instantly comes on.

•SOFT - Light starts dim and gradually increases to full brightness. Light gradually dims to half-bright, pauses, and then continues dimming to off when motion is no longer detected and after selected ON- TIME.

•FLASH - Light flashes on then off twice before turn- ing on full brightness.

For eave mount only:

❒Swing the sensor head towards the clamp screw joint.

Clamp Screw	Controls

❒Then rotate the sensor head clockwise 180° so the controls face down.

Light Shield	Controls
Light Shield
Opening
	Controls

If the sensor pops out of the ball joint, loosen the clamp screw and push the sensor back into the ball joint. Tighten the clamp screw when done.

598-1315-02

INSTALLATION