Fortress Technologies FS-50 Programmable Options, Passive Locks, Parking Lights on with Disarm

Page 22

PROGRAMMABLE OPTIONS Cont.

3. PASSIVE ARMING Passive Arming With Ignition or Last Door:

With this option ON, the unit will arm itself 30 Seconds after the ignition is turned off and/or the last door has been closed. Lights will flash twice when last door is closed indicating passive countdown. If a door is reopened, the system will wait and begin countdown again when closed. The LED will flash rapidly during 30 second count down.

4.ACTIVE RE-ARM:Active Re-arming allows the system to re-arm itself 30 seconds after disarmed with the transmitter if a door has not been opened. The status LED flashes rapidly during 30 second re-arm countdown. This is handy if the vehicle is accidentally disarmed without your knowledge.

5.PASSIVE LOCKS:

This option controls whether the doors will lock when Passive Arming occurs. Note: This may increase the risk of locking keys in the vehicle.

6. PARKING LIGHTS ON WITH DISARM:

Keeps parking lights on when system is disarmed to assist in locating and providing illumination near your vehicle when approaching at night for safety.

7. Data Port Protocol:

This option controls the Data Port Protocol for OFA Series modules or SL Series modules. The default is set for SL Series Protocol. This option has no effect on conventional wiring of Bypass modules. Both OFA series and SL series are now 2-Way Protocol.

8. Double Button Press for Remote start and Trunk release:

This option will allow you to change whether the Remote starter and Trunk release activate by a single ½ second press or a double button ½ second press.

9. SIREN CHIRPS WITH REMOTE START ACTIVATION:

This option controls whether the system gives 3 short siren chirps when engaging a remote start.

10. DISARM WITH TRUNK POP (AUX. OUTPUT 1):

Controls whether the system will or will not DISARM when the trunk pop or AUX. feature is used. When the feature is turned on the unit will DISARM when opening trunk or using an auxiliary device controlled by the Green/Red wire.

11. 10/60 Sec. OPEN DOOR WARNING:

This setting changes the delay time in which the alarm system begins to monitor the Door circuit. This option can prevent the alarm from giving warning chirps on vehicles with a delayed dome light.

22

Image 22
Contents Disclaimer IntroductionREV Table of Contents PR PRE-INSTALLATION ConsiderationsComponent Mounting Antenna Diagram WindshieldGreen Mode B Optional Turbo Timer Input Wiring 9-PIN ConnectorGreen Mode a Start Activation Input Brown + Siren OutputNegative Auxilary Output +12V Constant GREEN/RED Orange Negative Starter Disable/Anti-Grind Output Starter DisableWiring 3-PIN Connector Wiring 6-PIN High Current ConnectorWiring 5-PIN Connector Trigger Inputs Wiring 5-PIN Connector White +12V Brake ResetBLUE/ORANGE Starter #3 Wire 4 PIN Output ConnectorYELLOW/BLACK OEM Rearm Output BLUE/ORANGE Starter VIOLET/WHITE AUXWiring 4-PIN Shock Sensor 22 Gauge wires Shock SensorPower Door Locks Wiring & System Types Door Lock Wiring Negative Trigger Doorlock WiringSeparate DRIVER’S Door Unlock Wiring Negative Trigger Door LocksTachless Adjustment Tachless ModeImportant Notes Tach Finder Tach Mode & Tach Finder FeatureTach Finder Feature Tach ProgrammingTimed Crank Mode HOW to USE this FeatureProgrammable Options Diesel Glow Plug DelayTo Engage Option Programming Option Programming Table Engine Monitoring Programmable Option DescriptionsAUTOLOCK/UNLOCK W/IGNITION Parking Lights on with Disarm Programmable OptionsPassive Locks Siren Chirps with Remote Start ActivationLock DURING/AFTER Remote Start Door LOCK/UNLOCK Pulse TimeDouble Unlock Pulse Siren Chirps with ARM/DISARMULTRA-SMART Tachless Voltage Adjustment Diesel Glow Plug DelayFactory Horn Chirps / Pulses Aux #4 Time control 1 sec. to 255 sec. Default = 12 seconds Programmable Option ResetTurbo Timer Mode Option Reset Restore to Default Remote Programming Diagram Vehicle Control Vehicle OperationVehcle Notes Remote Start Diagnostics Alarm Trigger DiagnosticsParking Light Flashes = Manual Transmission Mode Error Jumper PIN Diagram Securing JumpersStart IGN ACC Wiring Diagram AlarmData Port Diagram See Option # 7 on