Design LED 12 Brick | Elation Professional 12 Brick II manual

Design LED 12 Brick II ™

4.On/Off Power Switch – Controls main power to the unit.

5.Power Output Jack – Use this jack to jump power to another Design LED 12 Brick II

™

6.Power Input/Fuse Holder Assembly – This assembly holds the safety fuse as well as provides a female IEC connector for a power cord. Always replace the fuse with an exact match unless otherwise specified by an authorized Elation Service Technician. Using a fuse other than that specified could seriously damage the unit and will void your manufactures warranty.

7.Eye-Bolt - Use this bold as a safety-cable rigging point. Always secure any installation with a properly rated safety-cable.

8.LED MENU DISPLAY – Four segment LED menu display, details all menu functions

9.DMX In Jack – This jack accepts an incoming DMX signal via a male, 3-pin or a 5-pin XLR jack.

10.DMX Out Jack - This jack is used to send an incoming DMX signal to the next fixture in the DMX chain via a female, 5-pin XLR jack.

11.ESC BUTTON – This button is used to access and exit the fixture’s on-board menu system.

12.UP BUTTON – This button is used to scroll forward when navigating through the fixture’s menu system.

13.DOWN BUTTON – This button is used to scroll backwards when navigating through the fixture’s menu system.