ASSEMBLY INSTRUCTIONS/OPERATIONS
3)Using the wrench, remove the four (4)
4)Remove the drum access plate from the driveshaft.
5)Clean and remove any excessive material
6)Install the loaded flail drum on the driveshaft. If utilizing the milling flails or other flail configurations that are unidirectional, determine that the flails are facing the direction of rotation. FIGURE 22.
7)Install the drum access plate on the driveshaft. The left, vertical side of the access plate should align tight against the main frame.
8)Install the four
9)If the Floor Planer is powered by an engine, reconnect the engine spark plug wire. If powered by an electric motor and the machine is to be used immediately, reconnect the extension cord of Floor Planer to the power source. Determine that the ON/OFF switch located on the operator handle is in the OFF position.
DANGER
UNEXPECTED MACHINE START UP CAN RESULT IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.
10)Removing a loaded drum from the driveshaft is accomplished by reversing the above steps.
FIGURE 22
TRANSPORTING THE FLOOR PLANER.
Application: All Models.
The Floor Planer has an operational weight that prohibits one person from loading and/or unloading it alone by conventional, physical efforts.
DANGER
DO NOT ATTEMPT TO LIFT THE FLOOR PLANER UP INTO A TRANSPORTATION VEHICLE WITH THE USE OF ONE PERSON ALONE. DO NOT ATTEMPT TO LOWER THE FLOOR PLANER FROM A TRANSPORTATION VEHICLE WITH THE USE OF ONE PERSON ALONE. LIFT AND/OR LOWER THE FLOOR PLANER ONLY BY THE USE OF A POWER TAILGATE UNIT, A SUITABLE HOIST UNIT OF PROPER CAPACITY AND/OR CONFIGURATION OR BY THE USE OF A PROPER QUANTITY OF PERSONNEL IN PROPER PHYSICAL CONDITION.
1)A lifting bail device can be used to facilitate lifting by a mechanical device incorporating a chain and suitable attachment device. The location of the lifting
8FP FLOOR PLANER SERIES | OPERATION AND PARTS MANUAL REV #1 (10/27/06) | PAGE 24 |
|
|
|