ASSEMBLY INSTRUCTIONS/OPERATIONS
2)Install a spacer washer next to the outside side plate of the wide section. Next, install a flail. Follow with a spacer washer and continue the sequence until the section is full. FIGURE 16.
Normal installation procedure (fine finish) for pentagonal flails
1)Install a spacer washer next to the outside side plate of the narrow section. Next, install a flail. Follow with a spacer washer and continue the sequence until the section is full. FIGURE 17.
2)Install a flail next to the outside side plate of the wide section. Next, install a spacer washer. Follow with a flail and continue the sequence until the section is full. FIGURE 18.
FIGURE 16
FIGURE 17
Normal installation procedure for milling flails
1)Install three spacer washers next to the outside side plate of the narrow section. Next, install a flail. Follow with two spacer washers and continue the sequence until the section is full. The tungsten carbide inserts must be installed to form a continuous planing surface. FIGURE 19.
FIGURE 18
FIGURE 19
2)Install a flail next to the outside side plate of the wide section. Next, install two spacer washers. Follow with a flail and two spacer washers. Install another milling flail followed by three spacer washers. Finally, install the remaining flail and one spacer washer. The tungsten carbide inserts must be installed to form the same, continuous planing surface as in Step 1. FIGURE 20.
3)Milling flails can also be installed on the drum without the use of spacer washers.
8FP FLOOR PLANER SERIES | OPERATION AND PARTS MANUAL REV #1 (10/27/06) | PAGE 22 |
|
|
|