ASSEMBLY INSTRUCTIONS/OPERATIONS
8)Clean and inspect the driveshaft and housing for wear and damage. If any damage is evident, replace the applicable component.
9)Clean the outside bore diameter of the replacement bearing. Apply a suitable amount of anaerobic adhesive/sealant to the outside diameter of the bearing. Press the replacement bearing into the bearing housing until its seats itself against the flange. FIGURE 42.
FIGURE 40
FIGURE 41
9)Position the bearing block on the arbor press with the bearing facing up. Support the inner race of the bearing with an appropriate sized bushing to absorb the thrust created by pressing the driveshaft into the bearing. FIGURE 43.
10)Clean the bearing journal area of the driveshaft with a suitable solvent. Apply a suitable amount of anaerobic adhesive/sealant to the bearing journal area of the driveshaft. Press the driveshaft into the bearing housing until it seats against the bearing. FIGURE 44.
11)Reinstall the snap ring on the driveshaft.
CAUTION
Wear safety glasses and other appropriate safety apparel when removing the snap ring or performing any work with an arbor press. Caution all onlookers about the possibility of flying debris and personal injury.
FIGURE 42
FIGURE 43
8FP FLOOR PLANER SERIES | OPERATION AND PARTS MANUAL REV #1 (10/27/06) | PAGE 36 |
|
|
|