Electrical
Grounding Instructions
This jointer must be grounded while in use to
protect the operator from electric shock.
In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an
Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified electrician. Improper connection of the
Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded. Use only three wire extension cords that have
Repair or replace a damaged or worn cord immediately.
115 Volt Operation
Referring to Figure 9:
As received from the factory, your Woodworking Jointer is ready to run at
(A). A temporary adapter, which looks like the adapter shown in (B), may be used to connect this plug to a
The temporary adapter should only be used until a properly grounded outlet can be installed by a qualified electrician. This adapter is not applicable in Canada. The green colored rigid ear, lug, or tab, extending from the adapter, must be connected to a permanent ground such as a properly grounded outlet box.
230 Volt Operation
Referring to Figure 10:
If 230V,
1.Disconnect the machine from the power source.
2.The JET Woodworking Jointer motor has four numbered leads that are factory connected for 115V operation, as shown in
(A). For 230V operation reconnect the leads as shown in (B).
3.The 115V attachment plug (C) supplied with the Woodworking Jointer must be replaced with a UL/CSA listed plug suitable for 230V operation (D). Contact your local Authorized JET Service Center or qualified electrician for proper procedures to install the plug. The Woodworking Jointer must comply with all local and national codes after the
4.The Woodworking Jointer with a
(D). No adapter is available nor should be used with the
Figure 10
Figure 9