Unpacking
Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Jointer is assembled and running properly.
Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.
Shipping Contents
Note: This unit is shipped in two cartons.
Stand Carton
1 Stand with Motor
1Stand Cover with Mounting Hardware
1Dust Chute with Mounting Hardware
Stand Carton
Main Unit Carton
1Bed Assembly
1Fence Assembly
1Cutterhead Guard (A)
1Belt Guard (E)
1
4
41/4 Flat Washers (M)
1Lock Handle, Flat Washer, and Lock Nut for Fence (G)
1Fence Handle (F)
3Lock Bolts (B)
33/8" Lock Washers (C)
2Handwheel Assembly (N)
1Can of
1Operating Instructions and Parts Manual (J)
1Warranty Card
2Push Blocks (K)
Tools Included for
112/14mm Open End Wrench (O)
18/10mm Open End Wrench (P)
13mm Hex Wrench (Q)
Tools Included for
112/14mm Open End Wrench (O)
18/12mm Open End Wrench (P)
13mm Hex Wrench (Q)
14mm
18mm Hex Wrench
Additional Tools Required
#1 Cross Point Screw Driver
Main Unit Carton
8