Assembly
Unpacking and Cleanup
1.Carefully finish removing all contents from both shipping cartons. Compare contents of the shipping cartons with the list of contents above. Place parts on a protected surface.
2.Report any shipping damage to your local distributor.
3.Clean all rust protected surfaces (bed, fence, etc.) with kerosene or diesel oil. Do not use gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces.
Cutterhead knives are dangerously sharp! Use extreme caution when cleaning. Failure to
comply may cause serious injury!
4.Apply a thin layer of paste wax to the bright surfaces of the fence and tables to prevent rust.
5.Set packing material and shipping cartons to the side. Do not discard until machine has been set up and is running properly.
Installing Bed to Stand
Referring to Figure 1:
1.Place bed assembly (A) on top of stand (B). Be sure the identification label (C) on the bed faces the same direction as the switch (D) on the stand.
2.Line up two holes in the stand top (E) with holes in the bed assembly by viewing through the access door in rear side of the stand.
3.Attach stand to bed assembly by using two 3/8" lock bolts and lock washers (Figure 2). Hand tighten only at this time.
4.Line up the third hole in the stand (F) with the hole in the bed assembly by viewing through the dust chute (G).
5.Install the third 3/8" lock bolt and lock washer through the dust chute (G) to secure the bed to the stand.
6.Tighten all three lock bolts with a 14mm wrench.
Figure 1
Figure 2
9