Installing Fence to Bed

Referring to Figure 3:

1.Take the lock handle (E), flat washer (F), and lock nut (G) from the carton.

2.Place the fence assembly (A) onto the table

(B). Be sure the key stock (D) on the bed lines up with the channel (C) in the fence casting.

3.Place the flat washer (F) on hole (H)*; insert the lock handle (E) through the fence casting and the table casting.

4.Thread the lock nut (G) onto the lock handle

(E). Make sure the tab on the nut faces up and engages the slot in the table casting.

*Note: For rabbeting operations use hole (J).

Installing the Drive Belt

Referring to Figure 4:

1.Place V-belt (A) onto cutterhead pulley (B) and through opening in stand.

2.Pull V-belt down and place onto motor pulley (C).

Note: If the belt is difficult to roll on the pulley, loosen the motor mounting screws.

3.Check to make sure that motor pulley and cutterhead pulley are vertically aligned and the V-belt does not contact the sides of the opening in the base. If the pulleys are not aligned, remove belt and adjust the motor pulley in or out on the motor shaft and then re- attach the belt.

4.The V-belt is properly tensioned when finger pressure on the belt half way between the two pulleys causes 1/2" deflection (Figure 5). If the belt is too loose, loosen the four motor mount bolts, push down on the motor to tension the V- belt, and tighten the mounting bolts.

5.After two hours of operation, check belt tension again. Readjust the tension if necessary.

Figure 3

Figure 4

Figure 5