a.A steady green light beside the Console Port means the system has powered up correctly.
b.A steady green light beside the uplink port indicates a 10Mbit or 100Mbit per second connection respectively. If both lights are unlit, the Uplink to your network failed.
3.Make the device connections. Each EthIR Switch is equipped with two rows of RJ 45 jacks. The top jack of each port is the Ethernet “pass through” port. The bottom jack of each port is the infrared connection port.
a.If your intention is to connect only infrared devices to the EthIR Switch, see “Infrared Mode” below.
b.If you are connecting a combination of infrared and Ethernet devices to the EthIR Switch, see Pass Through Mode (ES208 / 216 only) on the next page.
Install EthIR Switch (ES101 / 301 / 3011b / 1000)
To install the single port EthIR Switch:
1.Plug in one end of an Ethernet UTP cable into the uplink port and the other end into a network patch panel or Ethernet wall jack leading to a patch panel.
2.Connect the EthIR Beam to one end of a
3.Power up the system by plugging it into an AC outlet. Once powered the EthIR Switch indicator lights display its status illustrated as follows:
a.Uplink - (indicates state of network connection)
b.Status - (indicates progress of obtaining an IP address from DHCP server)
c.Power - ES101 (indicates state of power)
d.PC - ES301 (indicates Ethernet port in use)
The LED indicator light on the EthIR Beam (EB100) indicates data transmission via infrared.
|
|
| Uplink |
|
| Status |
| Power | PC |
|
|
|
|
|
| (101 only) | (301 only) | ||
|
|
|
|
|
|
|
| ||
| Status |
| ON |
| OFF | OFF | OFF | ||
|
| OFF |
| ON | ON | ON | |||
|
|
|
|
|
| Blinking (½ seconds) |
|
| |
| Power On |
| OFF |
| ON then OFF | ON | OFF | ||
|
|
| ON if uplink |
| ON if the IP is found. | ON | OFF | ||
| System Init |
| is up |
| Blinking if the IP is |
|
| ||
|
|
|
|
| not found. |
|
| ||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| OFF if the unit is bad |
|
| |
| Connected by |
| ON if uplink |
| ON if the IP is found. | ON | N/A | ||
|
| is up |
| Blinking if the IP is |
|
| |||
| IrLAN |
|
|
|
| ||||
|
|
|
|
| not found |
|
| ||
|
|
|
|
|
|
|
| ||
| Connected by |
| ON if uplink |
| ON if the IP si found. | ON | N/A | ||
|
| is up |
| Blinking if the IP is |
|
| |||
| IR/PPP |
|
|
|
| ||||
|
|
|
|
| not found |
|
| ||
|
|
|
|
|
|
|
| ||
| Fatal Error |
| N/A | OFF | OFF/ON | N/A | |||
Beam EB100
OFF
LOW
HIGH
LOW
LOW
HIGH Blinking if there is activity HIGH Blinking if there is activity.
N/A
