Chapter 2

Installation

Introduction to EthIR LAN Components

Clarinet EthIR LAN includes EthIR Switch and EthIR Beam. Model number description follows. For description of “Pass Through” mode refer to page 2-6:

ES208 - 8 port Pass Through ES216 - 16 port Pass Through

ES608 - 4 port EthIR LAN with 4 PDA sockets ES101 - single port infrared only

ES301 - single infrared port with additional Ethernet port and OBEX function ES3011b - single infrared port with 802.11b uplink and OBEX function ES1000 - single infrared port with flash memory for content and OBEX function

After EthIR LAN is installed you must configure it for your network. See Chapter 3, “Configuring EthIR LAN” for additional information on this topic.

Installation Requirements

Wiring

The EthIR Switch (ES208 / 216 / 608) requires standard UTP Category 3 or 5 wire with 4-pair wiring to the EthIR Beam. The EthIR Switch (ES101/301/3011b/1000) single port uses a mini-DIN connector cable. The EthIR Switch uplink supports both 100Base-T, 10Base-T Ethernet and 802.11b RF. Please note: 100Base-T4 is not supported.

Power (ES 208 / 216 / 608)

The EthIR Switch automatically detects and supports both the US and European 110/220 power supply and configures itself accordingly.

Power (ES101 / 301 / 3011b / 1000)

The ES101 will have a power supply specific to the installed region.

Resetting

To reset the system, unplug the EthIR Switch power cord and wait at least 4 seconds before plugging the unit in again.

2-1

Page 13
Image 13
Clarinet Systems manual Introduction to EthIR LAN Components, Installation Requirements