Powermatic PJ882 Optional Accessories, Replacement Parts, Trouble Probable Cause Remedy

Page 32

	Trouble	Probable Cause	Remedy

	Machine will not		Double check to confirm all electrical
	start/restart or		Double check to confirm all electrical
	start/restart or		connections are correct. Refer to
	repeatedly trips	Miswiring of the unit.	connections are correct. Refer to
	repeatedly trips		appropriate wiring diagrams on pages
	circuit breaker or		appropriate wiring diagrams on pages
	circuit breaker or		44 through 46 to make any needed
	blows fuses.		44 through 46 to make any needed
	blows fuses.		corrections.
			corrections.

			If the on/off switch is suspect, you
			have two options: Have a qualified
		On/off switch failure.	electrician test the switch for function,
		On/off switch failure.	or purchase a new on/off switch and
			or purchase a new on/off switch and
			establish if that was the problem on
			changeout.

Optional Accessories

6296046	Knives (set of 3)
2230035	Knife Setting Gauge
6285917	Push Block

Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848 between 7:30 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately.

32

Image 32

Contents Inch Parallelogram Jointer Part No. M-1610079Warranty and Service More Information WMH Tool Group WarrantyTable of Contents Page Page Page Specifications Introduction DescriptionContents of the Shipping Container UnpackingInstallation and Assembly Tools required for assemblyInstalling Switch Arm Installing Cutterhead GuardGrounding Instructions Dust CollectionExtension cords Volt, Single Phase OperationThree Phase Operation Adjustments Drive Belt TensionDrive Belt Replacement Fence MovementTo slide fence forward or backward To tilt fence forwardSetting the 90 Stop Setting the 45 Forward StopFence Stops To tilt fence backwardTable and Knife Adjustments Setting the 45 Backward StopFence Removal Locking HandlesSetting Tables Parallel Back of outfeed table shown Page Page Page Infeed Table Depth Stop Setting Infeed Table Depth of CutOutfeed Table Stop Screws Infeed Table Stop Screws Replacing Knives in the CutterheadEliminating Play in Tables Operating ControlsOperation Hand Placement Always use a hold down or push block when surfacing stockSurfacing Edge JointingRabbeting Jointing Short or Thin WorkJointing Warped Surfaces BevelingDirection of Grain Skewing Shear CuttingMaintenance Sharpening KnivesUse caution when working around sharp knives Cutterhead RepairsProbable Cause Remedy Troubleshooting Operating ProblemsTrouble Troubleshooting Mechanical and Electrical Problems Trouble Probable Cause Remedy Optional AccessoriesReplacement Parts Parts List Cutterhead Assembly Index No. Part No Description Size QtyParts List Fence Assembly Fence Assembly Parts List Outfeed Table and Base Assembly Outfeed Table and Base Assembly Parts List Infeed Table Assembly PJ882-246 Infeed Table Assembly Parts List Stand Assembly TS-081B022 Stand Assembly Electrical Connections 1 Phase, 230 Volt Electrical Connections 3 Phase, 230 Volt Electrical Connections 3 Phase, 460 Volt Page WMH Tool Group