Powermatic PJ882 operating instructions Unpacking, Contents of the Shipping Container

Page 8

Unpacking

Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Jointer is assembled and running properly.

Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

Contents of the Shipping Container

1 Jointer

1Cutterhead guard

2Push blocks

1Combination wrench (8-10 mm)

2Hex wrenches (3mm and 5 mm)

1Aluminum knife gauge

1Owner's Manual

1Warranty Card

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

8

Image 8
Contents Inch Parallelogram Jointer Part No. M-1610079Warranty and Service More Information WMH Tool Group WarrantyTable of Contents Page Page Page Specifications Introduction DescriptionContents of the Shipping Container UnpackingInstallation and Assembly Tools required for assemblyInstalling Switch Arm Installing Cutterhead GuardGrounding Instructions Dust CollectionExtension cords Volt, Single Phase OperationThree Phase Operation Adjustments Drive Belt TensionDrive Belt Replacement Fence MovementTo slide fence forward or backward To tilt fence forwardSetting the 90 Stop Setting the 45 Forward StopFence Stops To tilt fence backwardTable and Knife Adjustments Setting the 45 Backward StopFence Removal Locking HandlesSetting Tables Parallel Back of outfeed table shown Page Page Page Infeed Table Depth Stop Setting Infeed Table Depth of CutOutfeed Table Stop Screws Infeed Table Stop Screws Replacing Knives in the CutterheadEliminating Play in Tables Operating ControlsOperation Hand Placement Always use a hold down or push block when surfacing stockSurfacing Edge JointingRabbeting Jointing Short or Thin WorkJointing Warped Surfaces BevelingDirection of Grain Skewing Shear CuttingMaintenance Sharpening KnivesUse caution when working around sharp knives Cutterhead RepairsProbable Cause Remedy Troubleshooting Operating ProblemsTrouble Troubleshooting Mechanical and Electrical Problems Trouble Probable Cause Remedy Optional AccessoriesReplacement Parts Parts List Cutterhead Assembly Index No. Part No Description Size QtyParts List Fence Assembly Fence Assembly Parts List Outfeed Table and Base Assembly Outfeed Table and Base Assembly Parts List Infeed Table Assembly PJ882-246 Infeed Table Assembly Parts List Stand Assembly TS-081B022 Stand Assembly Electrical Connections 1 Phase, 230 Volt Electrical Connections 3 Phase, 230 Volt Electrical Connections 3 Phase, 460 Volt Page WMH Tool Group