Unpacking
Open shipping cartons and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Jointer is assembled and running properly.
Compare the contents of your cartons with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.
Contents of the Shipping Container
The following are included with both straight and helical cutterhead models
(see Figures 2, 3, 4):
1Jointer Assembly (A)
1Stand Assembly (B)
1Switch Arm (C)
1Dust Chute (D)
1Drive Belt (E)
1Door (F)
2Push Blocks (G)
1 Handwheel (H)
1Cutterhead Guard (J)
2Open End Wrenches, 12/14, 8/10mm (K)
1Hex (Allen) Wrenches, 3mm, 6mm (L)
1Screwdriver (M)
1Hardware Bag containing:
3 Carriage Bolts,
6 Flat Washers, 3/8” (BB)
3 Lock Washers, 3/8” (CC)
3 Hex Nuts, 3/8” (DD)
4 Socket Head Cap Screws,
4 Flat Washers, 5/16” (FF)
4 Lock Washers, 5/16” (GG)
4 Pan Head Screws,
2 Pan Head Screws, M6 x 12 (KK)
2 Flat Washers, M6 (LL)
1Owner's Manual (not shown)
1Warranty Card (not shown)
Included with straight cutterhead models (60C) only:
1 Knife Setting Gauge Assembly (N)
Included with helical cutterhead models (60HH) only (see Figure 5):
2Star Point Screwdrivers (O)
5Knife Inserts (P)
10Knife Insert Screws (R)
Figure 2
Figure 3
Figure 4
Figure 5 (helical cutterhead only)
8