ENGLISH
c.Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d.Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
e.Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f.Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
g.Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation.
5. Service
a.Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained.
Additional Safety Instructions for Heat Guns
•Always switch off before putting tool down.
•Extreme care should be taken when stripping paint, the peelings, residue and vapors of paint may contain lead, which is poisonous. Once deposited on surfaces, hand to mouth contact can result in the ingestion of lead. Exposures to even low levels of lead can caused irreversible brain and nervous system damage; young and unborn children are particularly vulnerable. Do not smoke, eat or drink in a work area that could or may be contaminated by lead. Lead based paints should only be removed by a professional and should not be removed using a heat gun.
•When removing paints you should ensure that your work area is enclosed. It is advisable to wear a dust mask.
•Do not burn the paint. Keep the nozzle at least 25mm (1”) from the surface as this keeps the temperature below the required 450°C. If you are scraping from a vertical position then you should scrape downwards to prevent the paint from falling back into the heat gun and burning. Dispose of all paint debris safely and ensure
that the work area is thoroughly cleaned after completing the job.
•Do not use in a damp atmosphere or where flammable gases may be present or use near combustible materials. Spaces behind boards, ceilings and floors and wall cavities in timber frame constructed houses can contain flammable materials. Check before using the heat gun.
•Allow the tool to cool fully before storing.
•Ensure adequate ventilation when using heat guns as toxic fumes may be produced.
•Do not use as a hairdryer! The air temperature is far higher than a hairdryer.
•Do not obstruct either the air intake or nozzle outlet as this may cause excessive heat build up resulting in damage to the tool.
•Do not direct the hot air blast at other people.
•Do not touch the metal nozzle as it becomes very hot during use and remains hot for up to 30 minutes after use. Do not look down the nozzle while the unit is working because of the high temperatures being produced.
•Do not allow paint to adhere to the nozzle or scraper as it could ignite after a time.
•Do not operate your heat gun whilst it is hanging by the hanging hook.
•A fire may arise if the appliance is not used with care.
•Do not place the nozzle against anything while using or immediately after use.
•Do not poke anything down the nozzle as it could give you an electric shock.
•Do not apply to the same place for a long time;
•Do not leave the appliance unattended when it is switched on.
•Place the appliance on its stand after use
Safety of others
•This appliance is not intended for use by persons(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge,unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
•Children should be supervised to ensure that they do not play with the appliance.
4