6. REPLACING COIL ASSEMBLIES
1.Push the Power Switch “Off.” Wait for the heater tip to reach room temperature.
2.Remove the heater tip from the handle assembly. DO NOT USE METAL TOOLS (SUCH
AS PLIERS) TO REMOVE HEATER TIPS.
3.To disconnect the Coil Assembly from the Soldering Handle depress the button on the Coil Assembly and pull it away from the Soldering Handle assembly.
4.Insert the new Coil assembly into the handle assembly, you will feel a ‘click’ as it seats.
7.TROUBLESHOOTING
a.Power LED Not ON
•Check the power cord
•Check to see that you have mains voltage
•Check to see if the power switch is in the ON position
b.Tip Does Not Heat
•Is the LED Illuminated?
•Is the
•Is the
•Is the Tip Firmly Inserted onto the
•Has a replacement
If you cannot resolve the problem after conformation of the above, please contact your local OK International representative.
4
www.okinternational.com
8. SPECIFICATIONS
Power Supply |
|
Ambient Operating Temperature | 10 - 40°C |
Maximum Enclosure Temperature | 65°C |
Input Line Voltage | 100 - 240 VAC |
Input Line Frequency | 50/60 Hz |
Power Consumption | 90 Watts max. |
Output Power | 60 Watts max. at 22°C ambient temperature |
Output Frequency | 470 KHz |
Power Cord | 1.83 cm 18/3 SJT |
Dimensions (approx.) | W = 80 mm (3.1"), D = 160 mm (6.3"), |
| H = 115 mm (4.5") |
Soldering Handle and Coil Assembly |
|
< 2 mV True RMS, | |
< 2 ohms DC, unit on | |
Idle Temperature Stability | ± 1.1°C in still air |
Handle Cord Assembly Length | 122 cm – burn proof, ESD safe |
Connector | |
Dimensions (approx.) |
|
Overall length (with tip) | 214 mm (8.43") with standard tips |
Grip diameter | 13 mm (0.51") |
Tip to grip | 58 mm (2.28") |
Tip shaft diameter | 5.5 mm (0.22") |
Tip length | 52 mm (2.05") (typical) |
Workstand |
|
Dimensions | W = 105 mm (4.1"), D = 175 mm (6.9"), |
| H = 90 mm (3.5") |
5
www.okinternational.com