Powermatic WP2510 operating instructions Set Software Limit Hi/Lo End, Set Tolerances

Page 27

6. Set Software Limit (Hi/Lo End)

There are High and Low software limits. If these are exceeded, the display will give an error message.

To set the Lo_End press

To set the Hi_End press

7. Set Tolerances

The tolerance defines the accuracy of the positioning.

Step 1: Press

Display

.........................[default]

Step 2:

Enter the value for tolerance.

 

Step 3:

Press

to confirm or press

to clear.

27

Image 27
Contents Inch Planer More Information Warranty and ServiceTable of Contents Page Page Page TEFC, 1/2HP, 3Ph Introduction SpecificationsUnpacking Contents of the Shipping ContainerDust Hood Installation and AssemblyVolt Operation Grounding InstructionsController Set-Up AdjustmentsConverting from 230 Volt to 460 Volt Test RunKnife Inserts Feed RateBelt Tension Opening HoodAnti-Kickback Fingers Planer’s Feed SystemChipbreaker Pressure Bar Table Adjustments Feed Restriction Test Cutting and TroubleshootingClip Marks Maintenance OperationLubrication Front Panel Overview Controller M15S Operating InstructionsOperation Modes Manual ModeStart/Stop/Cancel Setting Target ValueExample Fast Program 10 sets Entering preset target valuesExecute Select Counting direction Select Positioning ModeSet Tolerances Set Software Limit Hi/Lo EndTo set low speed limit Set Low Speed LimitSet Linear Correction Enter Parameter Setttings ModeLoad Datum Values Check Software VersionExample 13. IN/MM Conversion Set Device ResolutionCalibration 16. M15S Troubleshooting DisplayPossible cause Incorrect operation Excluding Press to clear 17. M15S Specifications Troubleshooting Planer Operating Problems Troubleshooting Mechanical and Electrical Problems Replacement Parts Column Assembly Index No. Part No Description Size Qty Parts List Column AssemblyWP2510-458 Gearbox Assembly Parts List Gearbox Assembly Parts List Cutterhead Assembly 6012162 Table Assembly Parts List Table Assembly Base Assembly Parts List Base Assembly WP2510-660 122 Parts List Top Cover Assembly Parts List Electrical Box Assembly Electrical Connections 230Volt Electrical Connections 460Volt WMH Tool Group
Related manuals
Manual 56 pages 50.77 Kb