Powermatic WP2510 operating instructions Unpacking, Contents of the Shipping Container

Page 8

Unpacking

Open shipping container and any smaller boxes and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the planer is installed and running properly.

Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.

NOTE: To remove the box from atop the planer table, loosen the table lock handle, push in the elevating handwheel (see Figure 3) and rotate the handwheel to lower the table.

Contents of the Shipping Container

1 Planer

1Dust Hood – (A)

4Foot Pads – (B)

1 Air Impact Screwdriver – (C)

1RA-30E 460V Overload Relay – (D)

5Star Point Screwdrivers – (E)

1Breaker Bar – (F)

1Air Valve – (G)

1Air Valve Mounting Bracket – (H)

1Air Valve Pressure Gauge – (J)

20Flat Head Spline Socket Screws, M6x14 – (K)

10Spline Bits, T-20 – (L)

10Replacement Knife Inserts – (M)

1Handle with Knob – (N)

3Open End Wrenches, 17-19, 22-24, and 12- 14 mm – (O)

1 Reversible Screwdriver – (P)

4 Hex Wrenches, 3, 4, 5, and 8mm – (R)

8Button Head Socket Screws, M6x12 – (S)

8Lock Washers, M6 – (T)

8Flat Washers, M6 – (U)

1Operating Instructions and Parts Manual

1Warranty Card

Read and understand the entire contents of this manual before attempting set-up or operation! Failure to comply may cause serious injury.

8

Image 8
Contents Inch Planer Warranty and Service More InformationTable of Contents Page Page Page Introduction Specifications TEFC, 1/2HP, 3PhContents of the Shipping Container UnpackingInstallation and Assembly Dust HoodGrounding Instructions Volt OperationAdjustments Converting from 230 Volt to 460 VoltTest Run Controller Set-UpFeed Rate Belt TensionOpening Hood Knife InsertsPlaner’s Feed System Anti-Kickback FingersChipbreaker Pressure Bar Table Adjustments Test Cutting and Troubleshooting Feed RestrictionClip Marks Lubrication MaintenanceOperation Controller M15S Operating Instructions Front Panel OverviewManual Mode Operation ModesSetting Target Value Start/Stop/CancelExample Entering preset target values Fast Program 10 setsExecute Select Positioning Mode Select Counting directionSet Software Limit Hi/Lo End Set TolerancesSet Low Speed Limit To set low speed limitEnter Parameter Setttings Mode Set Linear CorrectionCheck Software Version Load Datum ValuesExample Set Device Resolution 13. IN/MM Conversion16. M15S Troubleshooting Display CalibrationPossible cause Incorrect operation Excluding Press to clear 17. M15S Specifications Troubleshooting Planer Operating Problems Troubleshooting Mechanical and Electrical Problems Replacement Parts Column Assembly Parts List Column Assembly Index No. Part No Description Size QtyWP2510-458 Gearbox Assembly Parts List Gearbox Assembly Parts List Cutterhead Assembly 6012162 Table Assembly Parts List Table Assembly Base Assembly Parts List Base Assembly WP2510-660 122 Parts List Top Cover Assembly Parts List Electrical Box Assembly Electrical Connections 230Volt Electrical Connections 460Volt WMH Tool Group
Related manuals
Manual 56 pages 50.77 Kb