Powermatic WP2510 Possible cause Incorrect operation Excluding Press to clear

Page 34

Display

Possible cause: a. no sensor

b.9-pin connector is loose

c.wire broken

d.the gap between sensor and tape is too large

Excluding: Check the sensor, sensor cable and sensor connector.

Display

Possible cause: Incorrect operation.

Excluding: Press to clear.

Display

This message appears after power-on and indicates battery discharged. The C-type battery MUST be replaced to resume the operation of the device. Change as follows:

1.Open the planer’s top right side panel to access the rear of the Controller.

2.Turn the power off. Be careful not to move the table during power off. Replace the battery and turn the power on. The device will resume normal operation.

34

Image 34

Contents Inch Planer Warranty and Service More InformationTable of Contents Page Page Page Introduction Specifications TEFC, 1/2HP, 3PhContents of the Shipping Container UnpackingInstallation and Assembly Dust HoodGrounding Instructions Volt OperationTest Run AdjustmentsConverting from 230 Volt to 460 Volt Controller Set-UpOpening Hood Feed RateBelt Tension Knife InsertsPlaner’s Feed System Anti-Kickback FingersChipbreaker Pressure Bar Table Adjustments Test Cutting and Troubleshooting Feed RestrictionClip Marks Operation MaintenanceLubrication Controller M15S Operating Instructions Front Panel OverviewManual Mode Operation ModesSetting Target Value Start/Stop/CancelExample Entering preset target values Fast Program 10 setsExecute Select Positioning Mode Select Counting directionSet Software Limit Hi/Lo End Set TolerancesSet Low Speed Limit To set low speed limitEnter Parameter Setttings Mode Set Linear CorrectionCheck Software Version Load Datum ValuesExample Set Device Resolution 13. IN/MM Conversion16. M15S Troubleshooting Display CalibrationPossible cause Incorrect operation Excluding Press to clear 17. M15S Specifications Troubleshooting Planer Operating Problems Troubleshooting Mechanical and Electrical Problems Replacement Parts Column Assembly Parts List Column Assembly Index No. Part No Description Size QtyWP2510-458 Gearbox Assembly Parts List Gearbox Assembly Parts List Cutterhead Assembly 6012162 Table Assembly Parts List Table Assembly Base Assembly Parts List Base Assembly WP2510-660 122 Parts List Top Cover Assembly Parts List Electrical Box Assembly Electrical Connections 230Volt Electrical Connections 460Volt WMH Tool Group

Related manuals

Manual 56 pages 50.77 Kb