RIDGID R4330 manual Leveling the Table Extensions, Lock NUT

Page 16

ASSEMBLY

LEVELING THE TABLE EXTENSIONS

See Figure 9.

The infeed and outfeed table extensions are attached to the planer. Shipped in a folded, upright position, the table extensions must be in the down position before planing can begin. For accurate planing, table extensions must be level with the planer table.

NOTE: For optimum performance, always check to make sure the table extensions are level before beginning planing operations.

Place a straight edge or level across both the planer table and table extensions.

If adjustment is necessary, lift table extensions and loosen lock nuts. Adjust stop screws (one on each side) until extension table is level with planer table.

Press down on the table extension to ensure the table extension is properly seated.

Tighten lock nuts securely when adjustments are complete.

STOP

SCREWS

lock NUT

TABLE

EXTENSION

STRAIGHT

EDGE

TABLE

EXTENSION

PLANER

TABLE

Fig. 9

Image 16

Contents OPERATOR’S Manual Table of contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules  Never Start a Tool When ANY ROTATiNGSpecific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Authorized Service Center for repair. When servicSpeed and Wiring ElectricalExtension Cords Grounding InstructionsMotor safety protection Motor Overload ProtectorAnti-Kickback Pawls radial arm and table saws ArborBevel Cut ChamferFeatures Product SpecificationsAMP Motor Automatic FeedBlade / Tool Storage Dust HoodHood Hex key Magnetic Blade tool Loose PartsDust Hood knobs Assembly UnpackingMounting the Planer to workbench Clamping Planer to WorkbenchInstalling handwheel knob Installing the Dust HoodLeveling the Table Extensions Lock NUTOperation ApplicationsThickness planing Planing tipsPower Switch Avoiding SnipeWarped Wood To lock the PlanerAdjusting the planing depth See Figure Depth GaugeIndicator Replaning using repeat-a-cutCutterhead Adjustments Thickness Scale AdjustmentBlade Adjustment ScrewsRepeat-a-cut Replace the replane indicatorReplace the handwheel and hex head screw Cleaning MaintenanceLubrication Cord storage Brush ReplacementBrush Cap Drive Belt Hex key Loo sen Tighten Blade ReplacementBlade Troubleshooting Warranty DAY Satisfaction Guarantee PolicyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information Model No R4330 Serial No