RIDGID R4330 manual Replaning using repeat-a-cut, Cutterhead, Indicator

Page 20

OPERATION

Push slightly on the board and allow the automatic feed to take the board.

Release the board to allow the automatic feed to function properly. Do not push or pull on the workpiece.

Move to one side at the rear of the planer and receive the planed lumber by grasping it in the same manner as it was fed. Do not grasp any portion of the board which has not gone past the outfeed area of the table.

REPLANING using repeat-a-cut™

See Figure 14.

The planer has a replane feature using preset markers for repetitive planing. The Repeat-A-Cut™allows you to plane material at a set measurement. The maximum depth of the replane indicator is 1-3/4 in.

Raise cutterhead assembly to a height greater than 1-3/4 in.

Move the replane indicator to the desired height.

Lower the cutterhead assembly until it stops.

Stand to one side of the planer infeed area.

Turn switch ON ( l ).

Plane the workpiece (see Depth Gauge on page 19 for maximum depth of cut).

Repeat above steps until desired planing depth.

Fig. 13

Cutterhead

ASSEMBLY

REPLANE

indicator

Fig. 14

20

Image 20

Contents OPERATOR’S Manual Table of contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules  Never Start a Tool When ANY ROTATiNGSpecific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Authorized Service Center for repair. When servicSpeed and Wiring ElectricalExtension Cords Grounding InstructionsMotor safety protection Motor Overload ProtectorAnti-Kickback Pawls radial arm and table saws ArborBevel Cut ChamferFeatures Product SpecificationsAMP Motor Automatic FeedBlade / Tool Storage Dust HoodDust Hood knobs Loose PartsHood Hex key Magnetic Blade tool Assembly UnpackingMounting the Planer to workbench Clamping Planer to WorkbenchInstalling handwheel knob Installing the Dust HoodLeveling the Table Extensions Lock NUTOperation ApplicationsThickness planing Planing tipsPower Switch Avoiding SnipeWarped Wood To lock the PlanerAdjusting the planing depth See Figure Depth GaugeCutterhead Replaning using repeat-a-cutIndicator Adjustments Thickness Scale AdjustmentBlade Adjustment ScrewsReplace the handwheel and hex head screw Replace the replane indicatorRepeat-a-cut Lubrication MaintenanceCleaning Brush Cap Brush ReplacementCord storage Blade Blade ReplacementDrive Belt Hex key Loo sen Tighten Troubleshooting Warranty DAY Satisfaction Guarantee PolicyWhat is Covered Under the 3 Year Limited Service Warranty HOW to Obtain Service What is not CoveredCustomer Service Information Model No R4330 Serial No