SPECIFIC SAFETY RULES
NEVER PUT YOUR FINGERS into the dust hood or under the cutter guard.
ALLOW THE Cutterhead to reach full speed before using the planer.
Replacement parts. All repairs, whether electrical or mechanical, should be made at your nearest authorized service center.
DO NOT attempt to turn cutterhead with hands.
If any part of this TOOL is missing or should break, bend, or fail in any way, or should any electrical component fail to perform properly, shut off the power switch, remove the plug from the power source, and have damaged, missing, or failed parts replaced before resuming operation.
ALWAYS STAY ALERT! Do not allow familiarity (gained from frequent use of your planer) to cause a careless mistake. ALWAYS REMEMBER that a careless fraction of a second is sufficient to inflict serious injury.
make sure the work area has ample lighting to see the work and that no obstructions will interfere with safe operation BEFORE performing any work using your planer.
ALWAYS TURN OFF TOOL before disconnecting it to avoid accidental starting when reconnecting to power supply.
IF THE POWER SUPPLY CORD IS DAMAGED, it must be replaced only by the manufacturer or by an authorized service center to avoid risk.
THIS TOOL should have the following markings:
a)Wear eye protection.
b)Keep hands away from cutterhead.
c)Do not operate saw without guards in place.
d)Do not perform any operation freehand.
e)Never reach around saw blade.
f)Turn off tool and wait for blades to stop before moving workpiece or changing settings.
g)Disconnect power (or unplug tool as applicable) before changing blades or servicing.
h)No load speed.
SAVE THESE INSTRUCTIONS. Refer to them frequently and use to instruct other users. If you loan someone this tool, loan them these instructions also.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemi- cals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•lead from
•crystalline silica from bricks and cement and other masonry products, and
•arsenic and chromium from
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.