RIDGID R4330 manual Repeat-a-cut, Replace the handwheel and hex head screw

Page 22

ADJUSTMENTS

repeat-a-cut™

See Figure 17.

Plane a scrap piece of wood and measure the depth of the finished piece. If an adjustment is needed:

Unplug the planer.

Pull the replane indicator straight out to remove.

Using the hex key provided, remove the hex head screw from the depth adjustment handwheel. Remove the handwheel.

Remove the screws on the top and right side panel of the planer. Carefully lift and pull the side panel cover off.

Lower the cutterhead assembly until it stops against the stop screw.

Using an accurate ruler or a scrap piece of wood, check the measurement against the replane indicator setting.

If adjustment is necessary, use a wrench to loosen the lock nut and adjust the stop screw to the correct height.

Once the adjustment is made, retighten the lock nut and stop screw securely.

Replace the top and side panel, and secure using the set screw.

	Replace the handwheel and hex head screw.	LOCK NUT
	Replace the replane indicator.

REPLANE

INDICATOR

STOP SCREW

Fig. 17

22

Image 22

Contents OPERATOR’S Manual Table of contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules  Never Start a Tool When ANY ROTATiNGSpecific Safety Rules Symbols Symbol Name DESIGNATION/EXPLANATIONService Authorized Service Center for repair. When servicExtension Cords Speed and WiringElectrical Grounding InstructionsMotor safety protection Motor Overload ProtectorBevel Cut Anti-Kickback Pawls radial arm and table sawsArbor ChamferFeatures Product SpecificationsBlade / Tool Storage AMP MotorAutomatic Feed Dust HoodHood Hex key Magnetic Blade tool Loose PartsDust Hood knobs Mounting the Planer to workbench AssemblyUnpacking Clamping Planer to WorkbenchInstalling handwheel knob Installing the Dust HoodLeveling the Table Extensions Lock NUTThickness planing OperationApplications Planing tipsWarped Wood Power SwitchAvoiding Snipe To lock the PlanerAdjusting the planing depth See Figure Depth GaugeIndicator Replaning using repeat-a-cutCutterhead Blade Adjustment AdjustmentsThickness Scale Adjustment ScrewsRepeat-a-cut Replace the replane indicatorReplace the handwheel and hex head screw Cleaning MaintenanceLubrication Cord storage Brush ReplacementBrush Cap Drive Belt Hex key Loo sen Tighten Blade ReplacementBlade Troubleshooting What is Covered Under the 3 Year Limited Service Warranty WarrantyDAY Satisfaction Guarantee Policy HOW to Obtain Service What is not CoveredCustomer Service Information Model No R4330 Serial No