Delta TP400LS instruction manual Fastening Planer to Stand

Page 10

2.Fasten cutterhead raising and lowering handle (A) Fig. 8, to shaft using the M5x.8x20mm hex socket head screw (C) with wrench supplied.

3.Rotate handle (A) to the operating position as shown in Fig. 9, and tighten set screw (D).

FASTENING PLANER TO STAND

Place the planer on the stand and align the four holes in the base of the machine, two of which are shown at (A) Fig. 10, with the four holes in the top of the stand. Place the M8x1.25x35mm hex head flange bolt through the holes in the planer and the stand, and thread the M8x1.25 flange nut onto the hex head flange bolt and tighten securely. Only operate planer, attached to stand, on a flat level surface.

C

A

Fig. 8

A

D

Fig. 9

A

A

Fig. 10

10

Image 10

Contents 12½ Portable Planer General Safety Rules Safety Guidelines DefinitionsImportant Safety Instructions Failure to Follow These Rules MAY Result in Serious Injury Stay ALERT, Watch What YOU are DOING,Additional Safety Rules for Planers Failure to Follow These Rules MAY Result in Serious InjuryMotor Specifications Power ConnectionsGrounding Instructions Extension Cords Minimum Gauge Extension CordUnpacking and Cleaning Functional DescriptionPlaner Parts AssemblyStand Cutterhead Raising and Lowering Handle Lowering Extension TablesCutterhead Lock Handle Leveling Table ExtensionsFastening Planer to Stand Raising and Lowering Head Assembly Operating Controls and AdjustmentsLocking Switch OFF Position Starting Stopping PlanerRecommended Depth of CUT Disconnect Machine from Power SourceLeveling Table Extensions Knife Transfer Tool Storage Wrench StorageReplacing Knives Carrying HANDLE/STOCK Transfer BARKnives are Sharp Page Adjusting Height of Outfeed Roller Operation Brush Inspection Replacement MaintenanceLubrication Page Accessories Canadian PORTER-CABLE Delta Service Centers