Delta TP400LS instruction manual

Page 15

5.Figure 26 illustrates the cutterhead (C) locked in place allowing access to the knife locking bar (E).

6.Using the supplied wrench (E) Fig. 27, unscrew the six screws, five of which are shown at (F), only enough until locking bar (D) separates from knife, allowing knife to be removed.

7.Insert knife transfer tool (G) Fig. 28, underneath center of knife. Lift the knife transfer tool up until knife

(H) separates from pins (J) and pull out and remove knife as shown. NOTE: Knife transfer tool is magnetized, allowing it to attach to knife.

8.Rotate knife (H) Fig. 29, end-for-end, or using a new knife, position knife transfer tool (G) on top of knife as shown. Place knife in cutterhead with bevel up underneath locking bar (D), making sure pins (J) in cutterhead engage with holes (K) in knife.

D	D

C

E

Fig. 26

E

F

F

D

Fig. 27

G

J

H

Fig. 28

D

K J

K

J

H

G

Fig. 29

15

Image 15

Contents 12½ Portable Planer Safety Guidelines Definitions General Safety RulesImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Failure to Follow These Rules MAY Result in Serious InjuryFailure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for PlanersPower Connections Motor SpecificationsGrounding Instructions Minimum Gauge Extension Cord Extension CordsFunctional Description Unpacking and CleaningAssembly Planer PartsStand Leveling Table Extensions Lowering Extension TablesCutterhead Lock Handle Cutterhead Raising and Lowering HandleFastening Planer to Stand Starting Stopping Planer Operating Controls and AdjustmentsLocking Switch OFF Position Raising and Lowering Head AssemblyDisconnect Machine from Power Source Recommended Depth of CUTLeveling Table Extensions Wrench Storage Knife Transfer Tool StorageCarrying HANDLE/STOCK Transfer BAR Replacing KnivesKnives are Sharp Page Adjusting Height of Outfeed Roller Operation Maintenance Brush Inspection ReplacementLubrication Page Accessories Canadian PORTER-CABLE Delta Service Centers