Delta TP400LS Carrying HANDLE/STOCK Transfer BAR, Replacing Knives, Knives are Sharp

Page 14

A

Fig. 22

A

Fig. 23

CARRYING HANDLE/STOCK TRANSFER BAR

1.Your planer is provided with a foam covered carrying handle (A) Fig. 22, located on top of the machine, for ease in transporting the planer. Carrying handles are also provided at the base of the planer on each side which allow you to lift the machine with ease.

2.The carrying handle (A) Fig. 23, also doubles as a stock transfer bar for transferring stock from the outfeed to infeed end of the machine. This is helpful when planing long material, as the workpiece can easily be transferred back to the infeed end of the machine for additional cuts.

REPLACING KNIVES

The knives supplied with your planer are double edged and reversible, which enables you to turn the knives end-for- end when one edge becomes dull or chipped. To change the knives, proceed as follows:

DISCONNECT MACHINE FROM POWER SOURCE.

1.Raise head assembly all the way to the top.

2.Remove two screws (A) Fig. 24, and remove cutterhead guard (B) by pulling it straight out.

THE KNIVES ARE SHARP.

A

A

B

Fig. 24

3.Figure 26 illustrates the cutterhead guard removed, exposing the cutterhead (C).

4.Using the wrench supplied, rotate cutterhead by inserting end of wrench into the hex hole (A) Fig. 25. Rotate cutterhead until the cutterhead lock (D) Fig. 26, engages and locks the cutterhead (C) in place.

A

Fig. 25

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 12½ Portable Planer Important Safety Instructions Safety Guidelines DefinitionsGeneral Safety Rules Failure to Follow These Rules MAY Result in Serious Injury Stay ALERT, Watch What YOU are DOING,Additional Safety Rules for Planers Failure to Follow These Rules MAY Result in Serious InjuryGrounding Instructions Power ConnectionsMotor Specifications Extension Cords Minimum Gauge Extension CordUnpacking and Cleaning Functional DescriptionStand AssemblyPlaner Parts Cutterhead Raising and Lowering Handle Lowering Extension TablesCutterhead Lock Handle Leveling Table ExtensionsFastening Planer to Stand Raising and Lowering Head Assembly Operating Controls and AdjustmentsLocking Switch OFF Position Starting Stopping PlanerLeveling Table Extensions Disconnect Machine from Power SourceRecommended Depth of CUT Knife Transfer Tool Storage Wrench StorageKnives are Sharp Carrying HANDLE/STOCK Transfer BARReplacing Knives Page Adjusting Height of Outfeed Roller Operation Lubrication MaintenanceBrush Inspection Replacement Page Accessories Canadian PORTER-CABLE Delta Service Centers
Top Page Image Contents