Delta TP400LS instruction manual Planer Parts, Assembly, Stand

Page 8

PLANER PARTS

1- 12½" Portable Planer

2- Cutterhead raising and lowering handle

3- M5x.8x20mm hex socket head screw

4- Cutterhead lock handle

5- M6x20mm specia hex socket head screw

6- Wrench and handle assembly

7- Knife transfer tool

1

Fig. 1

4

2

3

5

7

6

Fig. 2

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

STAND

A - Top Brace 17-7/8" (4)

B - Bottom brace 22-1/4" (4)

C - Leg (4)

D - Rubber feet (4)

E - Carriage bolt M8x1.25x16mm (16)

F - Flange nut M8x1.25 (20)

*- Hex head flange screw M8x1.25x35mm (4) (For fastening planer to stand) * not shown

1.Align the holes in the bottom braces (B) Fig. 3 with the holes in the legs (C), insert a carriage bolt (E) through the leg and the bottom brace, and thread the flange nut

(F) onto the carriage bolt. Repeat this process for the remaining holes in the bottom braces and table legs. Do not completely tighten hardware at this time.

2.Assemble the top braces (A) Fig. 3 to the legs (C) in the same manner as step 1.

3.Insert the rubber feet (D) Fig. 3 onto the end of the legs (C) and tighten all hardware at this time.

E A

F

B

C

D

Fig. 3

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents 12½ Portable Planer Important Safety Instructions Safety Guidelines DefinitionsGeneral Safety Rules Failure to Follow These Rules MAY Result in Serious Injury Stay ALERT, Watch What YOU are DOING,Additional Safety Rules for Planers Failure to Follow These Rules MAY Result in Serious InjuryGrounding Instructions Power ConnectionsMotor Specifications Extension Cords Minimum Gauge Extension CordUnpacking and Cleaning Functional DescriptionStand AssemblyPlaner Parts Lowering Extension Tables Cutterhead Lock HandleCutterhead Raising and Lowering Handle Leveling Table ExtensionsFastening Planer to Stand Operating Controls and Adjustments Locking Switch OFF PositionRaising and Lowering Head Assembly Starting Stopping PlanerLeveling Table Extensions Disconnect Machine from Power SourceRecommended Depth of CUT Knife Transfer Tool Storage Wrench StorageKnives are Sharp Carrying HANDLE/STOCK Transfer BARReplacing Knives Page Adjusting Height of Outfeed Roller Operation Lubrication MaintenanceBrush Inspection Replacement Page Accessories Canadian PORTER-CABLE Delta Service Centers
Top Page Image Contents