Delta TP400LS instruction manual Knife Transfer Tool Storage, Wrench Storage

Page 13

KNIFE TRANSFER TOOL STORAGE

1.The knife transfer tool (A) Fig. 20, supplied with your planer, can easily be stored underneath the outfeed table extension (B) when not being used. A Velcro strip

(C) is provided on the tool and underneath the table for this purpose.

2.Figure 21 illustrates the knife transfer tool (A) stored underneath the outfeed table extension.

B

C

A

C

WRENCH STORAGE

The wrench (A) Fig. 21, can be stored in hole (B) located on the right rear side of the machine as shown.

Fig. 20

A

B

Fig. 21

13

Image 13

Contents 12½ Portable Planer General Safety Rules Safety Guidelines DefinitionsImportant Safety Instructions Stay ALERT, Watch What YOU are DOING, Failure to Follow These Rules MAY Result in Serious InjuryFailure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for PlanersMotor Specifications Power ConnectionsGrounding Instructions Minimum Gauge Extension Cord Extension CordsFunctional Description Unpacking and CleaningPlaner Parts AssemblyStand Cutterhead Lock Handle Lowering Extension TablesCutterhead Raising and Lowering Handle Leveling Table ExtensionsFastening Planer to Stand Locking Switch OFF Position Operating Controls and AdjustmentsRaising and Lowering Head Assembly Starting Stopping PlanerRecommended Depth of CUT Disconnect Machine from Power SourceLeveling Table Extensions Wrench Storage Knife Transfer Tool StorageReplacing Knives Carrying HANDLE/STOCK Transfer BARKnives are Sharp Page Adjusting Height of Outfeed Roller Operation Brush Inspection Replacement MaintenanceLubrication Page Accessories Canadian PORTER-CABLE Delta Service Centers