Kenmore 153.33616 owner manual Insulation Blankets, Front View, Ofdoor

Page 10

Breathing Hazard - Carbon Monoxide Gas

Energy Conservation Act standards with respect to insulation and standby loss requirements, making an insulation blanket unnecessary.

S

Install water heater in accordance with the instruction manual and NFPA 54.

To avoid injury, combustion and ventilation air must be taken from outdoors.

Do not place chemical vapor emitting products near water heater.

Breathing Hazard - Carbon Monoxide Gas

....

. :-'._,.,

Do not

obstruct

water

heater air

 

_'¢:S.

intake

with

insulating

blanket.

 

i_i',"_i" •

Gas and

carbon

monoxide

 

detectors

are

available,

 

_

_

lni_thal_-Wltne.rthe(?_inmaCCa°er_dance

Breathingcarbon monoxidecan cause brain damage or death. Always read and understandinstructionmanual

A gas water heater cannot operate properly without the correct amount of air for combustion, see Figure 9. Do not install in a confined area such as a closet, unless you provide air as shown in the Locating The New Water Heater section. Never obstruct the flow of ventilation air. If you have any doubts or questions at all, call your gas supplier. Failure to provide the proper amount of combustion air can result in a fire or explosion and cause death, serious bodily injury, or property damage.

12" MAX. (305 mr¢

1

VENTILATION

 

AIR

 

OPENING O

 

{

AIR DUCT

FRONTVIEW

13Q5mini

_

OFDOOR

 

 

FIGURE9.

If this water heater will be used in beauty shops, barber shops, cleaning establishments, or self-service laundries with dry cleaning equipment, it is imperative that the water heater or water heaters be installed so that combustion and ventilation air be taken from outside these areas.

Propellants of aerosol sprays and volatile compounds, (cleaners, chlorine based chemicals, refrigerants, etc.) in addition to being highly flammable in many cases, will also change to corrosive hydrochloric acid when exposed to the combustion products of the water heater. The results can be hazardous, and also cause product failure.

Insulation Blankets

Insulation blankets available to the general public for external use on gas water heaters are not necessary with Kenmore products. The purpose of an insulation blanket is to reduce the standby heat loss encountered with storage tank heaters, Your Kenmore water heater meets or exceeds the National Appliance

Breathing carbon monoxide can cause brain damage or death. Always read and understand instruction manual

_i& WARNING

Should you choose to apply an insulation blanket to this heater,

you should follow these instructions (See Figure 1 for identification of components mentioned below). Failure to follow these instructions can restrict the air flow required for proper combustion, potentially resulting in fire, asphyxiation, serious personal injury or death.

Do not apply insulation to the top of the water heater, as this will interfere with safe operation of the draft hood.

Do not cover the outer door, thermostat or temperature & pressure relief valve.

Do not allow insulation to come within 2" (50.8 mm) of the floor to prevent blockage of combustion air flow to the burner.

Do not cover the instruction manual. Keep it on the side of the water heater or nearby for future reference.

Do obtain new warning and instruction labels from Sears for placement on the blanket directly over the existing labels.

Do inspect the insulation blanket frequently to make certain it does not sag, thereby obstructing combustion air flow.

Combustion Air and Ventilation for

Appliances Located in Unconfined Spaces

UNCONFINED SPACE is space whose volume is not less than 50 cubic feet per 1,000 Btu per hour (4.8 m 3 per kW) of the aggregate input rating of all appliances installed in that space. Rooms communicating directly with the space in which the appliances are installed, through openings not furnished with doors, are considered a part of the unconfined space.

In unconfined spaces in buildings, infiltration may be adequate to provide air for combustion, ventilation and dilution of flue gases. However, in buildings of tight construction (for example, weather stripping, heavily insulated, caulked, vapor barrier, etc.), additional air may need to be provided using the methods described in Combustion Air and Ventilation for Appliances Located in Confined Spaces.

10

Image 10
Contents 153.336860 Gallon Propane 153.336900 Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.AModel no 153.336960 Gallon PropaneCould result in death or injury Symbol indicates a potentially hazardousIndicates An imminently Death or injuryExplosion Hazard Improper installation and use may result Property damageFire Hazard Feel water before bathing or showeringPage Tank Type Rate GAL8 Ventpipe Diameter RecoveryDimensions ModelBasic Tools Additional Tools Needed When Sweat SolderingMaterials Needed You may or may not need all these tools, depending on yourPilot & Main Burner ThermostatSupplied by Customers TGORemoving the Old Water Heater Facts to Consider About Location Property Damage HazardFront View Insulation BlanketsOfdoor ALL AIR from Inside Buildings FIGUREllWater Piping Hotter Water can ScaldInstallation KIT Temperature-Pressure Relief ValveInstallationcompleted Using LookatthetopofthewaterheaterThecoldwaterinlet.isFee/waterbeforebathingor showering Watertemperatureover125FFilling the Water Heater SeeFigure17 BeangledslightlyinwardPosition,drillasmallholethroughboththeventpipeand Gas PipingAgaslineofsufficientsizemustberuntothewaterheater Sediment TrapsGAS Piping with Flexibleconnector What to do if YOU Smell GAS GAS ControlTemperature Regulation Tank Sediment Cleaning Burner Inspection Burner CleaningAnode Rod Inspection Temperature-Pressure Relief Valve OperationHousekeeping DrainingService Drain Valve Washer ReplacementCLOSEthecoldwaterinletvalvetothewaterheater Start Up Conditions ChartBY-PASS Makenecessaryairsupplychangestocorrect Operational ConditionsOperational Conditions Leakage Checkpoints Leaking T&P Valve Page Page Key No. Part Description BurnerassemblyWhen ORDERINGREPAIRPARTS,ALWAYSGIVETHE Following INFORNT1ON Model Numbers9063457#37 Model Numbers Part Description 153.336400HA 153.3364649003474 By calling 1-800-366-PART 1-800-366-7278. If the parts youThis ISA Repair Parts LIST, Nota Packing List Sears Installation Service Limited Warranty on Tanks That LeakLimited Warranty on Parts Master Protection Agreements