Roberts Gorden EP-203 Pump Suspension, Wall Mounting Angle Assembly Wall Bracket Assembly

SECTION 5: PUMP INSTALLATION

5.2 Pump Suspension

WARNING

Suspension Hazard

Mount pump with materials with a minimum working load of 400 lbs (181 kg).

Failure of the supports can result in death, injury

or property damage.

5.2.1Wall Mounting Angle Assembly FIGURE 5: Wall Bracket Assembly

The standard method of mounting the EP-200 pump is on an outside wall and venting directly through the wall.

The pump may be mounted by using mounting angles as shown in Figure 5. The two mounting

angles form a mounting platform to which the pump will be attached.

Attach the mounting frame to the wall using anchors. Select an anchor that will give equal to or greater than 2000 lb ultimate pull-out strength.

NOTE: Typical assembly shown.	Lockwasher
Two (2) assemblies per	Flat Washer
each pump required.	Hex Nut

	Mounting
	Angle
Description	Part Number
Mounting Angle	01365000
Hex Bolt 5/16" x 3/4"	93413912
Flat Washer	95211600
Lockwasher	96411600
Hex Nut	92113900

Flat Washer

Hex Bolt

FIGURE 6: Wall Mounting Angle Assembly

11.5"

(292 mm)

7"

(178 mm)

9