Makita HR2611F Reversing switch action, Changing the quick change chuck for SDS-plus

Reversing switch action

Attaching the quick change drill chuck

B

A

1

010722

1.Reversing switch lever

		1.	Spindle
2	1	2. Quick change
			drill chuck
		3.	Change cover
			line
		4.	Change cover
	3	4
011562

Check the line of the quick change drill chuck shows the

CAUTION:

•Always check the direction of rotation before operation.

•Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool.

•If the switch trigger can not be depressed, check to see that the reversing switch is fully set to

position (A side) or(B side).

This tool has a reversing switch to change the direction of rotation. Move the reversing switch lever to theposition (A side) for clockwise rotation or theposition (B side) for counterclockwise rotation.

Changing the quick change chuck for SDS-plus

For Models HR2310T, HR2610T, HR2611FT

The quick change chuck for SDS-plus can be easily exchanged for the quick change drill chuck.

Removing the quick change chuck for SDS-plus

	1. Quick change
1	chuck for
	SDS-plus
	2. Change cover
	line
	3. Change cover
2	3
011561
CAUTION:

•Before removing the quick change chuck for SDS-plus, always remove the bit.

Grasp the change cover of the quick change chuck for SDS-plus and turn in the direction of the arrow until the change cover line moves from the symbol to the symbol. Pull forcefully in the direction of the arrow.

symbol. Grasp the change cover of the quick change drill chuck and set the line to the symbol.

Place the quick change drill chuck on the spindle of the tool.

Grasp the change cover of the quick change drill chuck and turn the change cover line to the symbol until a click can clearly be heard.

Selecting the action mode

For Models HR2300, HR2600, HR2601

1	1.	Rotation with
		hammering
	2.	Rotation only
	3. Action mode
		changing knob
2 3
010723

This tool employs an action mode changing knob. Select one of the two modes suitable for your work needs by using this knob.

For rotation only, turn the knob so that the arrow on the knob points toward the symbol on the tool body.

For rotation with hammering, turn the knob so that the arrow on the knob points toward thesymbol on the tool body.

CAUTION:

•Always set the knob fully to your desired mode symbol. If you operate the tool with the knob positioned halfway between the mode symbols, the tool may be damaged.

•Use the knob after the tool comes to a complete stop.

5